There is my latest print from the Raise 3D N2 plus. I went into one of England's special forests and did a photogrammetry of a tree then manipulated it in zbrush into a grail with tubes inside to pass fibre optic throw. The print took 12 hour at 100 microns and was about 10cm x 20cm x 10cm. After threading all the fibre optic I used led's connected to with batteries to light the cables up. Back in the magical woods again and having a crystal ball to hand I took some photos with an SLR with a 50 mm lens. And there you have my grail Light , which I am hoping to cast into metal soon.